HepatitER och blodsmitta

Chapter 3. Installing the KZPBA–CA Adapter
3.3.1 Connecting Internal SCSI Devices
Refer to your SCSI device documentation if you want to install one or more
SCSI device inside the host computer. The internal device(s) must be singleended.
To connect an internal SCSI device to the KZPBA–CA host adapter, you will
need one, or both, of the following cables depending on the requirements of your
internal drive.
•
A 50-pin connector SCSI ribbon cable with a 50-pin header internal connector
to mate with the KZPBA–CA host adapter 50-pin connector
•
A 68-pin connector SCSI cable with a 68-pin header internal connector to
mate with the KZPBA–CA host adapter 68-pin connector
NOTE
If you are connecting more than one internal SCSI
drive to the KZPBA–CA host adapter, there must
be additional connectors on the cable to
accommodate the additional drives.
Follow these steps to install the internal SCSI ribbon cable:
1.
Insert the connector on one end of the SCSI cable into the connector on the
host adapter (see Figures 3–3 and 3–4).
EK–KZPBA–UG. B01
3–5