Problem Solving 105 The tablet function does not operate normally Check Remedy If other tablet device drivers are installed, the tablet function may not When Easy Interactive Driver is installed, the Easy Interactive Virtual Tablet Driver that allows you to use the tablet operate normally. function is automatically installed. If other tablet device drivers are already installed and the tablet function does not operate normally, uninstall Easy Interactive Virtual Tablet Driver. To leave Easy Interactive Driver installed and only uninstall Easy Interactive Virtual Tablet Driver, go to Start - Control Panel - Programs - Uninstall a program and remove Easy Interactive Virtual Tablet Driver. Other problems No sound can be heard or the sound is faint Check Remedy Is the audio source connected correctly? Disconnect the cable from the Audio port, and then reconnect the cable. Is the volume adjusted to the minimum setting? Adjust the volume so that sound can be heard. s p.76 s Quick Start Guide Is A/V Mute active? Press the [A/V Mute] button on the remote control to cancel A/V Mute. s p.40 Is the audio cable's specification "No resistance"? When using a commercially available audio cable, make sure it is labeled "No resistance". No sound can be heard from the microphone Check Remedy Is the microphone connected correctly? Disconnect the cable from the Microphone (Mic) input port, and then reconnect the cable. Is the Mic Input Volume turned down too low? Adjust the Mic Input Volume so that sound can be heard. s Settings Menu - Mic Input Level p.76 The remote control does not work Check Remedy Is the remote control light-emitting area pointing towards the remote receiver on the projector during operation? Point the remote control towards the remote receiver during operation. Operating range s Quick Start Guide Is the remote control too far from the projector? The operating range for the remote control is about 6 m. s Quick Start Guide